Download Print this page

Troubleshooting - Lennox 4 Series Installation Manual

Multi split inverter air conditioner
Hide thumbs Also See for 4 Series:

Advertisement

5.0.

TROUBLESHOOTING

If the air-conditioning unit operates abnormally, please check the following items before contacting
an authorised service agent.
Table 9: Common Errors and Possible Causes
Failed start up
Stops after a short while of operation
Poor cooling effect
Poor heating effect
Controller not working
NOTICE:
If the air conditioner is not operating correctly after the above checks, please contact an authorised
service agent.
26
Errors
LENNOX MULTI SPLIT INVERTER
Slim Line Ducted Indoor Unit
Possible Causes
There is no power supply.
The breaker is open due to current leakage.
Voltage is too low.
The air inlet/outlet of the indoor/outdoor
unit is clogged.
The air filter screen is too dirty or clogged.
There are too many heat sources or people
in the room.
The door or window is open.
There are obstructions at the air inlet/outlet.
The set temperature is too high.
The air filter screen is dirty or clogged.
The door or window is not closed fully.
The set temperature is too low.
If the remote control crashes even after the
batteries have been replaced, open the
back cover and press the "ACL" button to
reset it.
Check that the remote control is in range of
the unit.
Check the receiver is not blocked by
obstacles.
For duct type units, operate the remote
control by pointing it at the
wired controller.
Replace the batteries in the wired controller
is enough.
13 23 50
|
lennoxaus.com.au

Advertisement

loading