3.
Wrapping the pipe with tape.
•
Wrap the pipe from the bottom of the outdoor unit to the top of the pipe where it enters the
wall.
•
Fix the wrapped pipe on the wall with clamps.
CAUTION
•
Do not wrap the pipe too tightly; otherwise the insulation effect will be reduced.
•
Make sure the drain hose is separated from the refrigerant pipe
•
Seal the wall penetration to prevent wind and rain ingress.
3.14. Connection to the Wiring Terminal
WARNING
•
All electrical work must be carried out by a licensed electrician.
a.
Single-Core Wire
1.
Strip 25mm of the insulating layer at the end of the wire with a wire stripper.
2.
Loosen the screw on the wiring board of the air conditioning unit.
3.
Use pliers to shape the end of the wire to a circle matching the size of the screw.
4. Insert the screw through the wire and then fix it to the wiring board.
20
Figure 19: Insulation for the Refrigerant Pipe
LENNOX MULTI SPLIT INVERTER
Slim Line Ducted Indoor Unit
13 23 50
|
lennoxaus.com.au