7.2 WIRED THERMOSTAT
Before installing the thermostat, unplug the power
cord from the power outlet.
)LUVW FRQQHFW WKH WZR WKHUPRVWDW ZLUHV WR WKH WHUPLQDO
block located at the rear on the right hand side of the
stove when facing it. Loosen the two middle screws
and insert the wires in the terminals. Tighten the two
screws. Open the thermostat and connect the wires
as per the manufacturer's instructions.
Open the thermostat and connect the wires as per
the manufacturer's instructions.
Connect one wire on "RH" and the other wire on "W".
5HG ZLUH MXPSHU FDQ UHPDLQ LQVWDOOHG )RU IXUWKHU LQ-
formation refer to the manufacturer's instructions.
Page 16
7.3 WIRELESS THERMOSTAT
If you are using a wireless thermostat or a hand
held thermostatic remote control, connect the two
thermostat wires to the terminal block located at the
rear on the right hand side of the stove while facing it.
If the receiver wires are equipped with quick-connect
terminals you can connect them directly to the stove's
wiring harness.
To do so, open the right hand side decorative panels
and disconnect wires (B) and (C) attached to the rear
of the terminal block (A) and connect them to the re-
ceiver.
8. COMBUSTION AIR SUPPLY
)RU PRELOH KRPH LQVWDOODWLRQ LW LV PDQGDWRU\ WR
connect the stove to an outside combustion air
VRXUFH ,QVXODWHG SLSH VKRXOG QHYHU H[FHHG
feet.
It is recommended to install an outside air inlet in or
near the room where the stove is installed. When
doing so, it is preferable to choose a wall which is
QRW H[SRVHG WR GRPLQDQW ZLQGV GHSHQGLQJ RQ WKH
conditions surrounding your house.
INSTALLATION MANUAL ECO-55 / ECO-55 CT / ECO-55 ST
NOTICE