Network Operators - ZyXEL Communications NR2301 User Manual

Table 22 APP MODULE > Network Settings (continued)
LABEL
Network Mode
Profile Mode
APN List
Name
User
Password
APN
Authentication
Type
IP Mode
Apply
Roaming
Roaming Mode
Apply
Return

8.3 Network Operators

Use the Network Operators screen to view available Public Land Mobile Networks (PLMNs) and select
your preferred network when the NR2301 is outside the geographical coverage area of the network to
which you are registered and roaming is enabled.
To access this screen, click APP MODULE > Network Operators.
Chapter 8 Network Settings
DESCRIPTION
Select the type of the network (5G-SA, 5G-NSA, or 4G) to which you want the NR2301 to
connect. Otherwise, select Auto to have the NR2301 connect to an available network using
the default settings on the SIM card. If the currently registered mobile network is not
available or the mobile network's signal strength is too low, the NR2301 switches to another
available mobile network.
Connections with different APNs (Access Point Names) may provide different services (such
as Internet access or MMS (Multi-Media Messaging Service)) and charge methods.
Select Auto to have the APN information automatically configured.
If you select Manual in the Connect Mode field, manually enter the APN information
provided by your service provider.
Select the APN profile from the list to configure.
Enter the descriptive name for this APN (of up to 64 ASCII printable characters).
Type the user name (of up to 64 ASCII printable characters) given to you by your service
provider.
Type the password (of up to 64 ASCII printable characters) associated with the user name
above.
Enter the APN (of up to 64 ASCII printable characters) given to you by your service provider.
The NR2301 supports PAP (Password Authentication Protocol) and CHAP (Challenge
Handshake Authentication Protocol). CHAP is more secure than PAP; however, PAP is
readily available on more platforms
Select an authentication protocol (PAP, or CHAP) used by the service provider. Otherwise,
select Auto to have the NR2301 accept either CHAP or PAP.
Select IPv4/IPv6 to allow the NR2301 to run IPv4 and IPv6 at the same time.
Select IPv4 if you want the NR2301 to run IPv4 only.
Select IPv6 if you want the NR2301 to run IPv6 only.
Click Apply to save your changes back to the NR2301.
Turn the switch button on
4G/5G roaming is to use your mobile device in an area which is not covered by your service
provider. Enable roaming to ensure that your NR2301 is kept connected to the Internet
when you are traveling outside the geographical coverage area of the network to which
you are registered.
Click Apply to save your changes back to the NR2301.
Click this button to return to the APP MODULE list.
NR2301 User's Guide
62
to enable roaming on the NR2301.