Test Run Of Indoor Unit - Toshiba MMD-UP0721HFP Series Service Manual

10-3. Test run of indoor unit

Cooling/Heating test run check
The test run for cooling/heating can be performed from either indoor remote controller or outdoor interface
P.C. board. Refer to the Installation Manual and Service Manual of outdoor unit for the procedure of the test
run from an outdoor interface P.C. board.
In case of wired remote controller
<RBC-AMT32E>
TEMP.
TIMER SET
TIME
FILTER
1,
RESET TEST SET CL
5
Procedure
Push [TEST] button for 4 seconds or more.
1
[TEST] is displayed at the display part and
the mode enters in TEST mode.
2
Push [ON/OFF] button.
Change the mode from [COOL] to [HEAT] using [MODE] button.
• Do not use [MODE] button for other mode except
3
[COOL]/[HEAT] modes.
• The temperature cannot be adjusted during test run.
• The trouble detection is performed as usual.
After test run, push [ON/OFF] button to stop the operation.
4
(Display on the display part is same to that in Procedure
Push [TEST] button to clear the TEST mode.
5
([TEST] display in the display part disappears and
status becomes the normal stop status.)
Note) The test run returns to the normal operation after 60 minutes.
2,
ON / OFF
4
FAN MODE
3
SAVE VENT
SWING/FIX UNIT LOUVER
<RBC-AMS41E>
TEMP .
FILTER UP/DN
PROGRAM DAY
1,
FLT.RESET TEST
5
Operation contents
1
.)
- 33 -
ON / OFF
SCHEDULE FAN MODE
TIME SAVE VENT
SET CL SWING/FIX UNIT LOUVER
TEST
TEST
2,
4
3