Toshiba MMD-UP0721HFP Series Service Manual page 113

Table 1. Setting data (CODE No. table (example))
CODE No. (DN)
01 Filter sign lighting time
02 Filter pollution level
03 Central control address
06 Heating suction temperature shift
0F Cooling only
10 Type
11 Indoor unit capacity
12 System address
13 Indoor unit address
14 Group address
19 Louver type (wind direction adjustment)
Temperature range of cooling/heating
1E
automatic SW control point
28 Power failure automatic recovery
2b Thermostat output SW (T10
31 Ventilation fan (standalone)
32 Sensor SW (Selection of static pressure)
5d High ceiling SW
60 Timer setting (wired remote controller)
77 Dual set point
b3 Soft cooling
b5 Occupancy sensor: Provided/None
Occupancy sensor: Enable/Invalid
b6
(Judgment time of absence)
b7 Occupancy sensor: Operation at absent time
d0 Remote controller operation save function
F0 Swing mode
F1 Louver fixing position (Flap No. 1)
F2 Louver fixing position (Flap No. 2)
F3 Louver fixing position (Flap No. 3)
F4 Louver fixing position (Flap No. 4)
F6 Presence of Application control kit
Fd Priority operation mode (FS unit)
FE FS unit address
Table 2. Type: Code No.10
Setting data Type
Fresh Air Intake
0016
Indoor Unit
Item Setting data
)
Model name
MMD-UP***HFP-*
- 113 -
Factory-set value
Depending on Type
0000: standard
0099: Not determined
Depending on Type
0000: Heat pump
Depending on model type
Depending on capacity type
0099: Not determined
0099: Not determined
0099: Not determined
Depending on Type.
0003: 3 deg (Ts ±1.5)
0000: None
0000: Thermostat ON
0000: Not available
0000: Body sensor
0000: Standard
0000: Available
0000: Unavailable
0001: Available
0000: None
0002: Enable (60 min.)
0000: Stand by
0001: Enable
0001: Standard
0000: Not fixed
0000: Not fixed
0000: Not fixed
0000: Not fixed
0000: None
0000: Heating
0099: Unfixed
Table 3. Indoor unit capacity: Code No.11
Setting data Model
0000* Invalid
0017 048 type
0021 072 type
0023 096 type
0024 112 type
0025 128 type