Table of Contents
Advertisement
5
When your performance is finished, press
Button 2 [Rec] or Button 3 [
Pause) to stop recording.
Dashes appear on the display in succession, indicating
that the recorded data is being saved. After the data is
saved, an "End" message appears, and the recorded Song
number appears. Pressing Button 3 [
NOTICE
While dashes appear on the display in succession, never turn off the power. Doing so may corrupt the data or damage
the internal memory or USB flash drive.
6
Record the second part. Press Button 2 [Rec]
to put recording in standby again.
The [Rec] lamp lights in red, and the [
lamp flashes.
NOTE
To cancel recording standby status, press Button 2 [Rec] again.
7
Hold down Button 1 [Select] for two seconds
to call up the recording part on the display.
8
Rotate the [VALUE] control to select the part
to record.
If the selected part contains already-recorded data, a dot
lights up at the right side of "L" or "r" on the display.
NOTICE
When the selected part contains data, keep in mind that
recording new data will overwrite the previously recorded
data.
NOTE
To cancel recording, press Button 2 [Rec].
9
Play the keyboard to start recording.
If you want to start playback of the recorded part previously, press Button 3 [
The [
/
R
K
NOTICE
If "FUL" appears on the display while or after recording, this indicates the internal memory or USB flash drive capacity
has become full and all or the part of the data will not be saved. We recommend that you first delete any unnecessary
User Songs (page 35) to ensure sufficient memory capacity.
32
TA3 SH3 SC3 Owner's Manual
/
R
R
] (Play/Pause) lamp lights, and the current measure number is shown on the display while recording.
] (Play/
K
/
] (Play/Pause) plays back the recorded Song.
K
/
] (Play/Pause)
R
K
When the part contains data:
Or
Lights up in red
Hold down for two seconds.
A dot lights up.
/
] (Play/Pause) to start recording.
R
K
Advertisement
Table of Contents
