Table of Contents
Advertisement
Operation
Changing the Orientation of the Device Guide and Electrode Plate
Figure 3-2
Electrode Spacing
Figure 3-3
Dimensions of the Device Guide Frame
CAUTION
Be sure to superpose the device guide onto the electrode plate in the proper orientation and
with the correct side facing up. Otherwise, adequate electrode spacing cannot be created.
As shown in Figure 3-3, when viewed from above, on the correct face of the device guide
there are two marks at positions 90 degrees apart clockwise from a single position.
Superpose the device guide onto the electrode plate so that all these marks are aligned with
the corresponding marks on the electrode plate. For a 0603 device, superpose the device
guide onto the electrode plate so that one mark is aligned with the corresponding mark on
34
Chapter 3
Advertisement
Table of Contents
