Advertisement
PC Control
of the TV
o When a program
is set, the TV can be controlled
from the PC using the RS-232C terminal,
The input signal
(PC/£V) can be selected,
the volume can be adjusted
and various other adjustments
and settings
can be
made, enabling
automatic
programmed
playing,
,, Attach
an RS-232C
cable cross-type
(commerciall
available)
to the supplied
Din/D-Sub
RS-232C for the
connections.
,, This operation
system should
be used by a person who is accustomed
to ush-/g computers.
Communication
conditions
Set the RS-232C communications
settings
on the PC to match the TV's communications
conditions.
The TV's communications
settings
are as follows:
9,600 bps
8 bits
None
1 bit
None
Communication
procedure
Send the control commands
from the PC via the RS-232C connector,
The TV operates
according
to the received
command
and sends a response
message
to the PC,
Do not send multiple
commands
at the same time, Wak until the PC receives the OK response
before sending
the next command,
Command
format
Eight ASCII codes
k CR
Command 4-digits: Command, The text of four characters,
Parameter 4-digits: Parameter 0
9, x, blank, ?
/
Command 4-digits
Paramet{r 4-digits
Return code
Parameter
Input the parameter values, aligning left, and fill with blank(s) for the remainder. (Be sure that 4 values are input for the
parameter.)
When the input parameter is not within an adjustable range, "ERR" returns. (Refer to "Response code format".)
No problem to input any numerical value for "x" on the table,
[0[
[ I [
[0191919[
I 13lol
I
[1 [0[01
[
IololsIsI
When "?" is input for some commands, the present setting value responds,
I I l
Q
-57
Advertisement
