Sony RDR-GX330 Operating Instructions Manual page 87

The remote does not function.
Batteries are weak.
Tile remote is too far from tile recorder.
The remote's nlauufacturer code returned to
the default setting when you replaced the
batleries. Reset the code (page 20).
The remote is not pointed at the remote
SellS(IF OU
the
recorder.
Different commaud modes are set for the
recorder and remote. Set the same
command mode (page 21). The def:mlt
command mode setting for this recorder and
the supplied remote is DVD3.
Press • STOP on the unit while the
recorder is turned off to check lhe current
comm:md mode.
The recorder does not operate properly.
Restart tile recorder. Press do'_ u I/@ on the
recorder lbr nlore than tell seconds until
"WELCOME" appears in the front panel
display.
When static electricity, etc.. causes tile
recorder to operate abnormally, turn off the
recorder and wait until the clock appears in
the front panel display. Then, unplug the
recorder and after leaving it o11" f or a while.
plug it in again.
Five numbersor letters are displayed in
the frontpanel display.
Tile self-diagnosis function was activated
(see the table on page 88).
Thedisctray doesnotopenafter youpress
OPEN/CLOSE.
It may take a few seconds for tile disc tray
to open after you have recorded or edited a
DVD. This isbecmlsethe recorder is adding
disc data to the disc.
The disc tray doesnot open and
"LOCKED" appears in the frontpanel
display.
Tile disc tray is locked. Cancel tileChihl
Lock (page 50).
The disc tray doesnot open and "TRAY
LOCKED"appears in the frontpanel
display.
Contact >our Sony dealer (11" local
authorized Sony service facility.
The disc tray does not open and you
cannot remove the disc after you press
OPEN/CLOSE.
Turn off tile recorder. Once tile clock
appears in the front panel display,
disconnect the AC power cord. (If the
recorder does not turn oft' or if the clock
does not appear in the front panel display,
disconnect the AC power cord anyway.)
Connect tile AC power cord again while
pressing down _' on the recorder, and
release the button when the disc tray opens.
Then. keep |/@ on the recorder pressed for
about tell seconds until "WELCOME"
appears in the front panel display.
"RECOVERY" appears in the front panel
_=:E.
display. _==
Tile recorder's recovery function was
activated when tile recorder was turued on _"
because the power was turned oil" or failed
during recording. Leave the recorder on
until "RECOVERY" disappears from the
front panel display.
"FAN ERROR" appears in the front panel
display.
,-b, Check that the vent on the rear of the
recorder is not blocked. Then. immediately
disconnect the AC power cord. Leave the
recorder off lk_ra while, then re-connect the
AC power cord. and press |/@ on the
recorder.
Mechanical sound is heard when the
recorder is off.
While tile recorder is adjusting tile clock for
the Auto Clock Set limctiou or during a
timer recording, operational noises (such as
the internal fall) may be heard, even when
the power is off. This is not a malfunction.
87