Advertisement
TROUBLESHOOTING
SYMPTOM
CAUSE
REMEDY
13. Certain discs take too long to
start or do not start.
There are errors when the disc code is
read (There is no damage to the unit).
@
Press STOP @ and stop the playback. Press the
PLAY » and start the playback again. (Repeat
this operation a few times.)
14. The player takes too long to find
point A during A-B (INTERVAL)
REPEAT operation.
Same as item 12 above.
@
Same as item 12 above.
(The repeat mode is cancelled).
1§, Picture other than instructed is
searched
in TIME
NUMBER
SEARCH mode.
Method of inputting numerals in the TIME NUMBER
SEARCH
mode differs, depending on
whether time number is recorded on disc in hours and minutes or minutes and seconds, as
shown below:
le.g.] 12-minute search
Disc in which time number is recorded in hours and minutes
CHP/TM
1
2
SEARCH | or
PLAY |
Disc in which time number is recorded in minutes and seconds
CHP/TM
1
2
i}
"minutes"
WHEN PLAYING BACK A COMPACT DISC
[SEARCH | or
PLAY
"seconds"
SYMPTOM
CAUSE
16. Player stops immediately
after playback is started.
Disc is loaded upside down
(CD, CDV,
onesided LD discs).
The playing surface of the discs is dirty.
Disc is not properly set on the disc table.
REMEDY
®
Load the disc correctly with the label side
upward.
e
Use a soft cloth and lightly wipe off the dirt
from the surface of the disc. If necessary,
moisten a cloth with diluted neutral detergent
to remove heavy dirt or fingerprint.
@ Set the disc properly.
17. No sound output
The
stereo
amplifier
is not correctly
connected.
You are not operating the stereo amplifier
correctly.
The connection terminals and/or the plugs
of the connection cords are dirty.
The plugs of the connection
cords are
disconnected, or are not fully pushed in.
The player is in pause mode.
@ Connect the amplifier correctly.
@
Refer to the operating
instructions for the
amplifier, and operate the amplifier correctly.
@
Clean the plugs and terminals
and connect
again.
@
Maxe
sure
that connections
are
made
correctly.
e@ Press
PLAY
® or PLAY/PAUSE
»/# and
restore the player to play mode.
18. Sound is distorted.
The audio output jacks are connected to the
PHONO jacks.
The connection terminals and/or the plugs
of the connection cords are dirty.
i
The plugs of the connection cords are not
fully pushed in.
@ Connect to the AUX, CD, VDP, LD or VCR
jacks.
e@ Clean the plugs and terminals and connect
again.
@
Push the plug in firmly.
37
<VRB1046>
Advertisement
