Download Print this page

Pioneer CLD-2090 Operating Instructions Manual page 36

Cd cdv ld player

Advertisement

TROUBLESHOOTING
WHEN A LASERVISION DISC IS BEING PLAYED
SYMPTOM
CAUSE
REMEDY
5. Disc is rotating but there is no | ®
picture.
*
The TV set is not turned on.
Wrong connections from player to TV.
Turn on TV.
Make correct connections.
6. Picture
continuously
moves | ®
vertically,
i
The TV vertical hold control is not adjusted
properly.
Adjust vertical-hold contro! on TV.
7. Particular
disc
does
not|
®
playback
properly.
The
playback stops in the middle
of the disc program.
The playing surface of the disc is dirty.
The disc is warped.
Use a soft coith and lightly wipe off the dirt
from the surface of the disc. If necessary,
moisten a cloth with diluted neutral detergent
to remove heavy dirt of fingerprints.
LD discs only
Put the disc into the protective envelope, then
place it on a flat desk top. Subsequently, place
a flat board e.g. glass plate on the disc, and
load it with about 4 ~ 5 kgs (about 10 Ibs). If it
is Jeft in this state for one day, sometimes the
warp will alleviated.
Heavy books
about 4 ~ 5 Kgs
(10 Ibs)
™ Glass plate
a Protective
envelope
Glass plate
8. Sound
is
distorted.
unnatural
or]
e
CX system is turned ON for dise which has
no mark,
Press CX to turn CX system OFF.
|
9. No
sound
output
during]
e
playback.
MULTI-SPEED
or STILL/STEP playback is
being
performed.
Sound
is output
only
during the normal play mode. The audio
signals are not output during other playback
modes,
Press PLAY or PLAY/PAUSE to set the player
to normal play mode.
10. During STILL playback, a part | *
of the screen image shakes.
Even if the disc is a standard play disc, there
may be some cases in which a fully still image
cannot be obtained, but this does not mean
that the player or the disc is defective.
11. CHAPTER
SKIP, CHAPTER | »
PROGRAM
PLAY
and}
CHAPTER NUMBER SEARCH
cannot be performed.
Disc in which
no chapter numbers
are
recorded is loaded.
Press DISP to check if chapter number is
displayed.
12. Certain discs take too long to | ¢
search for or do not search
for.
it takes time to read the recorded code,
depending on the disc.
Press CLEAR and picture will appear.
{At this point, a slightly different scene from
that which
has
been
searched
for may
appear.)
36
<VRB1046>

Advertisement

loading

This manual is also suitable for:

Cld-2290