Dimplex Edel 200 WATER/3 Installation Manual page 5

If the electrical supply cable is damaged, it
must be replaced by the manufacturer, their
customer service technicians, or by a qualifi ed
professional to prevent any risk of injury or
danger.
If the electrical supply cable is damaged, it
must be replaced by a cable or by a specifi c
kit available from the manufacturer or their
customer service department.
WARNING
Do not use any methods to accelerate the
defrosting or cleaning process other than
those recommended by the manufacturer.
The appliance must be stored in a room which
does not contain a perpetual fl ame or other
source of ignition (for example: open fl ame,
gas powered appliances or electric radiators
in use).
Do not pierce or burn.
Warning: refrigerant fl uids may be odourless.
The product is not intended to be operated
at an altitude greater than 2000m.
• Water may drain from the discharge pipe
of the pressure limiting device. This pipe
should be kept open to open air.
• Verify that the ventilation openings are not
obstructed.
• A new pressure-relief valve (not included)
must be installed and set to 6 bars on the
domestic cold water supply of the appliance.
We recommend using a membrane valve.
• This valve must conform to all national
standards in eff ect (NF EN 1487).
• The pressure-relief drainage outlet should
be installed in a frost-free place and in a
downward sloping position.
• This appliance can be used by children aged 3
and over, and people with a physical disability,
sensory or mental, or a lack of experience and
knowledge if they have been supervised or
informed about safe use of the device and
have understood the hazards involved.
• Children aged 3 to 8 years are only allowed to
turn on the tap connected to the domestic hot
water heat pump.
Maintenance - Troubleshooting
• Drainage: Turn off the power supply and the
cold water, open the hot water valves and then
set the safety group to the drainage position.
• The pressure-relief valve should be activated
regularly so as to eliminate limescale and
-
INSTALLER
DOMESTIC HOT WATER HEAT PUMP 200L & 270L
check for blockages.
• If the electrical supply cable is damaged, it
must be replaced by the manufacturer, their
customer service technicians, or by a qualifi ed
professional to avoid risk of injury.
• See the § «Dimensions» pages and the
§ «Installation» pages of this manual to fi nd
the necessary dimensions for the proper
installation of this appliance.
• See the § «Hydraulic connections» pages of this
manual to fi nd the minimum and maximum
water pressures and temperatures.
• Repair and maintenance of electrical
components must include initial safety checks
and component inspection procedures.
• If there is a defect that could compromise safety,
then no power supply should be connected to
the product until it is satisfactorily processed.
If the defect cannot be corrected immediately
but must be allowed to work then an adequate
interim solution must be used. This must be
reported to the equipment owner so that all
parties are informed.
• Initial security controls must include:
- Discharge of capacitors: Discharge safely to
avoid sparking.
- Verification that no electrical components
are energized and that no wiring is exposed
during system charging, recovery or purging.
- That there is continuity of connection to the
ground.
Repair of intrinsically safe components
Intrinsically safe components are the only
components that can be used in the presence of
a fl ammable atmosphere. The equipment used
must be properly sized.
-
MANUAL
5