Changing The Hydraulic Fluid - Toro 68038 Operator's Manual

11. Install the cowl and secure the latches.
Changing the Hydraulic
Fluid
Service Interval: Every 200 hours
Hydraulic fluid type: Mobil 424 Hydraulic Oil or
equivalent
Hydraulic fluid capacity: 28.4 L (30 US qt)
Note:
For temperatures below 1°C (35°F), the fluid
should be switched to thinner 15 weight hydraulic fluid.
1. Park the machine on a level surface.
2. Unlatch and remove the cowl
Figure 15).
3. Allow the machine to cool completely.
4. Remove the hydraulic tank breather/filler cap
(Figure 33).
CAUTION
The hydraulic breather/filler cap is
designed to pressurize the reservoir to
34 kPa (5 psi).
Loosen the cap slowly to avoid injury
whenever adding oil or working on the
hydraulic system. Use a wrench on the
hex directly under the cap.
1. Hex
5. Place a large drain pan under the drain plug
located at the bottom of the hydraulic tank.
6. Remove the drain plug and allow the oil to drain
into the pan.
7. When finished, install and tighten the drain plug.
Note:
Dispose of the used oil at a certified
recycling center.
(Figure 14
Figure 33
2. Breather/filler cap
8. Fill the hydraulic tank with approximately
28.4 liters (30 US quarts) of hydraulic fluid as
specified previously.
9. Start the engine and let it run for a 2 to 3 minutes.
10. Shut off the engine.
11. Check the hydraulic fluid level and add more
hydraulic fluid if necessary.
12. Install the cowl and secure the latches.
and
g019614
32