Using The Chronograph - Citizen Red Arrows AT8060-50E Manual

Using the chronograph

The chronograph can measure up to 60 minutes in units of 1/20 seconds.
1. Ensure that the crown is in position 0 .
Chronograph
2. Press and release the upper right button Ⓑ .
60 minute hand
50 10 ON
SMT
40 20 Chronograph
OFF
30 second hand
Ⓑ
3. Press and release the upper right button Ⓑ
0 1 2
4. Press and release the upper right button Ⓑ
Ⓐ
S
00
M
90 10
OK T
80 20
RX W
70 30
Chronograph 1/20
NO T
60 40
50
second hand
F
S
20
The watch enters the chronograph mode.
• As shown in the figure, the chronograph
minute, chronograph second, and chronograph
1/20 second hands point in the 12 o' c lock
direction.
to start measurement.
to suspend measurement.
• Pressing the upper right button Ⓑ again will
resume the measurement operation.
5. Press and release the lower right button Ⓐ to reset the measured time.
• Make sure to reset the time after finishing measurement.
6. Press and release the lower right button Ⓐ again to return to current time
indication.
• The current time indication will resume automatically when leaving the watch for
approx. 3 hours.
• When 30 seconds have elapsed after the measurement is started (or restarted), the
chronograph 1/20 second hand stops at the zero second position. However, the
measurement is still conducted.
• The chronograph cannot be used when the power reserve is at level 0. Even when
the power reserve is at level 1, we recommend charging the watch before using
the chronograph.
• Do not pull out the crown during chronograph measurement operation. The
measurement will stop.
Using the chronograph
21