Conveyor Belt Support - Blodgett MT2136E/AB Installation Operation & Maintenance

CONVEYOR BELT SUPPORT

NOTE: Conveyor belt support is shipped installed
on some units.
1. Slide the left conveyor support (with sprocket
on the end of the shaft) into the support tracks.
The sprocket must be inside the control box
after being pushed into the oven.
Figure 5
Installation
2. Install the drive chain around the drive motor
and the sprocket on the conveyor support.
Push the support back to tighten the chain.
3. Fasten the conveyor support to the control
box using a 1/4" x 20 hex bolt and nut.
4. Slide the right conveyor support into the sup-
port tracks until it touches the left stop.
7
Oven Assembly
Figure 6