Motorola V3-Razor Repair Manual page 23

V3-Razor Repair Manual
Removing and Replacing the Display Module Assembly
1. Remove the battery cover, battery, SIM, rear housing, antenna,
transceiver board assembly, flip assembly cover, and camera assembly,
as described in the procedures.
2. Use the disassembly tool to unseat the display module assembly flex
connector from its socket (see Figure 14)
Fig 14
3. Carefully and gently lift one corner of the display module assembly out
of the flip assembly.
4. Avoid damage to the electrical components on the flex while carefully
removing the display module assembly from the flip assembly.
5. Carefully lift the display lens away from the flip assembly
.
Page 23
Document –ED05020 rev.1.0
This document is considered an uncontrolled document when printed