Table of Contents
Advertisement
V3-Razor Repair Manual
Removing and Replacing the Flip Assembly Cover
1. Remove the battery cover, battery, SIM, antenna, rear housing, and
transceiver board assembly as described in the procedures.
2. Remove the 4 flip assembly screw caps.
3. Use the T-5 driver to remove the 4 screws from the flip assembly (see
Figure10). Retain the screws for re-assembly.
Fig10
4. Before removing the flip cover, note the locations of the smart buttons
on the sides of the flip assembly.
5. Use the disassembly tool to gently pry off the flip cover (see Figure 11).
Page 20
Document –ED05020 rev.1.0
This document is considered an uncontrolled document when printed
Advertisement
Table of Contents
