Table of Contents
Advertisement
V3-Razor Repair Manual
10. Replace the 2 housing screws and tighten to a final torque setting of
1.5 inch pounds. Do not over tighten.
11. Replace the antenna, SIM, battery, and battery cover as described in
the procedures.
Removing and Replacing the Antenna
1. Remove the battery cover, battery, SIM, and rear housing assembly as
described in the procedures.
2. Use the metal tweezers to grasp the rubber antenna grommets and
carefully remove them from the antenna assembly. See Figure 7. Set the
rubber grommets aside for reuse.
Fig7
3. Use the disassembly tool to release the antenna assembly as shown in
Figure 8.
Page 18
Document –ED05020 rev.1.0
This document is considered an uncontrolled document when printed
Advertisement
Table of Contents
