Table of Contents
Advertisement
V3-Razor Repair Manual
7. Insert the bottom edge of the of the battery cover into the rear housing,
then push the top edge of the cover down and snap it into place.
Removing and Replacing the Subscriber Identity Module (SIM)
1. Remove the battery cover and battery as described in the procedures.
2. Slide the SIM card out of the phone as shown.
3. Carefully lift the SIM from the phones.
4. To replace, insert the SIM into the holder, ensuring the keyed corner of
the SIM faces the outside of the phone.
5. Replace the battery and battery door as described in the procedures.
Removing and Replacing the Rear Housing
1. Remove the battery cover, battery, and SIM as described in the
procedures.
2. Using a Torx driver with a T-5 bit, remove the screws at each side of
the phone. Retain the screws for reassembly..
Page 16
Document –ED05020 rev.1.0
This document is considered an uncontrolled document when printed
Advertisement
Table of Contents
