Table of Contents
Advertisement
maintenance
WARNING:
FOR YOUR
OWN
SAFETY,
TURN
SWITCH "OFF" AND REMOVE PLUG FROM POWER
SOURCE
OUTLET
BEFORE
MAINTAINING
OR
LUBRICATING
YOUR BAND SAW.
Tires
Pitch and sawdust that build up on the tires should
be removed with a stiff brush or scraped off with a
piece of wood.
CAUTION: To avoid damaging the tires do not use a
sharp knife or any kind of solvent.
When the tires become worn they should be replaced.
When replacing
the tires, stretch them around the
wheels but do not glue them on.
ADJUSTING
BAND SAW BEVEL TRAVEL
If the band saw will not hold its position
when at a
bevel angle, and before the bevel lock is locked, or if
it is difficult to change the bevel angle, an adjustment
is necessary to correct
the force required to bevel
the band saw.
To adjust the force required to bevel the band saw,
locate the three (3) capscrews
holding the frame to
the motor mount. The capscrews
are located in the
recessed area behind the hub of the lower wheel at
the 2 o'clock, 6 o'clock, and 10 o'clock positions. Use
a 3!16-inch
hexagonal
"L" wrench that has a 4-inch
leg, reach between the spokes of the lower wheel to
the capscrews.
Adjust the capscrews
equally
until
the bevel action is smooth
and the saw will hold its
position before the bevel lock is locked.
General Maintenance
Keep your
band saw clean. Remove the sawdust
from the inside. Vacuum or blow out frequently,
Do not allow filth to build up on the table, the guides
orthe back-up bearings. Clean them with Craftsman
Gum and Pitch Remover.
CAUTION:
Do not immerse the backup bearings in
the gum and pitch remover.
Put a thin coat of paste wax on the table so that the
wood slides easily while cutting.
Light Bulb
To replace the light bulb remove the front cover, Use
a phillips screwdriver
to remove the lens and replace
the bulb. The light bulb is a 25 watt bayonet mount
bulb.
Motor
Frequently
blow or vacuum out any sawdust from
the motor.
Follow
lubrication
instruction
on the
motor label.
WARNING: TO AVOID EYE INJURY FROM BLOW-
ING DEBRIS,
WEAR SAFETY GOGGLES
WHEN
BLOWING
OUT SAWDUST.
WARNING: TO AVOID ELECTROCUTION
OR FIRE,
IMMEDIATELY
REPLACE
A WORN,
CUT,
OR
DAMAGED
POWER CORD.
Lubrication
All of the ball bearings are packed with grease at the
factory. They require no further lubrication.
ADJUSTING
THE UPPER
BLADE GUIDE
TRAVEL
If the upper guide bar will not move up and down
easily or falls when the lock knob is loosened, the
following
adjustment
should be performed.
1. Remove
the
Guide
Bar Lock
Knob
and the
washer which is under it.
2. Using a 7/16" socket or wrench, tighten the nut
which is under the washer to just tight.
3. Then loosen the same nut 1 turn.
4. Move the guide bar up and down to check for
smooth movement while still holding its position
when released.
5. Make further adjustments
to the nut as required
to get the guide bar to move smoothly
and hold
its position when released.
6. Reinstall the washer and Guide Bar Lock Knob.
WIRE CONNECTOR
SWITCH
(3 REQ)---_
BLACK
CORD
W/PLUG
GRE
BLACK
WIRING
DIAGRAM
BLACK
CORD
BLACK
CORD
29
Hide quick links:
Advertisement
Table of Contents
