The rear surface of the oven
•
gets hot when it is in use.
Ensure that the electrical
connection does not come into
contact with the rear surface so
as not to damage connections.
Do not trap the mains cable
•
between the oven door and
frame, do not route it over hot
surfaces as the cable insulation
may melt and cause a fire as a
result of a short circuit.
Any work on electrical
•
equipment must only be carried
out by authorized and qualified
persons.
In case of any damage, switch
•
off the appliance and
disconnect it from the mains. To
do this, switch off the circuit
breaker at the wall.
Ensure that the fuse rating is
•
compatible with the appliance.
Appliance safety
The appliance and its
•
accessible parts become hot
during use. Care must be taken
to avoid touching heating
elements inside the oven.
Children must be kept away
unless continually supervised.
Never use the appliance when
•
your judgment or coordination is
impaired by the use of alcohol
and/or drugs.
Keep all ventilation slots clear
•
of obstructions.
Use shelves as described on
•
page 7.
Page 4
Be careful when using alcoholic
•
drinks in dishes. Alcohol
evaporates at high
temperatures and may ignite
and cause fire when coming
into contact with hot surfaces.
Do not place any flammable
•
materials close to the appliance
as the sides may become hot
during use.
Do not heat closed tins and
•
glass jars in the oven. The
pressure build-up in the tin/jar
may cause the tin/jar to burst.
Do not place baking trays,
•
dishes or aluminium foil directly
onto the bottom of the oven.
The heat accumulation may
damage the bottom of the oven.
Do not use harsh abrasive
•
cleaners or sharp metal
scrapers to clean the oven door
glass as these may scratch the
glass surface.
Do not use steam cleaners to
•
clean the appliance as this may
cause an electric shock.
Do not use the appliance if the
•
front door glass has been
removed or is cracked.
Always use heat resistant oven
•
gloves when putting in or
removing dishes into/from the
hot oven.
Ensure the appliance is
•
switched off before replacing
the lamp to avoid the possibility
of an electric shock.
Some models feature a
•
protective film over stainless
steel trim. This film must be
carefully removed before using
the appliance.