Replacing The Oven Light; Troubleshooting - Defy DBO482 Instruction Manual

Oven light
The oven light is switched on by the function
selector switch and switches off when the
knob is returned to 0.

Replacing the oven light

DANGER: Before replacing the
oven lamp, ensure that the
appliance is disconnected from
mains and cooled down to avoid
the risk of an electrical shock. Hot
surfaces may cause burns!
The oven lamp is a special
electric light bulb that can resist
up to 300°C. See Technical
specifications for details. Oven
lamps can be obtained from
Authorised Service Agents.
Position of lamp might vary from
the figure.
To replace a faulty light bulb, proceed as
follows:
1. Disconnect the product from mains.
2. Turn the glass cover counter clockwise to
remove it.
3. Remove the oven lamp by turning it
counter clockwise and replace it with the
new one.
4. Install the glass cover.
Owner's responsibility
Since the following are not factory faults,
they are the owner's responsibility.
Damage to exterior finish.
•
Breakage of glass and other components.
•
Replacement of the light bulb.
•
Damage through improper use or
•
installation of the appliance.
Damage caused by moving the appliance
•
Page 18

6. Troubleshooting

Oven emits steam when it is in use.
It is normal that
steam escapes
during operation
The appliance emits metal noises while
heating and cooling.
When the metal
parts are heated,
they may expand
and cause noise.
The appliance does not operate.
The mains fuse is
defective or has
tripped.
The appliance is not
plugged into the wall
socket.
Oven light does not work.
Oven lamp is
defective.
Power is cut.
Oven does not heat.
Function and/or
Temperature are not
set.
If you have followed the
instructions and still have a
problem, contact the nearest Defy
Technical Support Centre. They
will be able to advise you on any
aspect of the product or send a
qualified technician to repair it.
Never attempt to repair a
defective appliance yourself.
Remember that you may be
charged for a service call even
during the warranty period if the
.
fault is due to or caused by any of
the above.
>>> This is not a
fault.
>>> This is not a
fault.
Check fuses in the
fuse box. If
necessary, replace or
reset them.
>>> Check the plug
connection.
>>> Replace oven
lamp.
>>> Check if there is
power. Check the
fuses in the fuse box.
If necessary, replace
or reset the fuses.
>>> Set the function
and the temperature
with the Function
and/or Temperature
knob/key.