Omron F3SG-SR/PG Manual page 40

Manual Reset Mode with Reset Switch Connector
[Wiring Example]
F39-JG C-L
S1
Function
EDM
Interlock *6
Operating Range Selection
Non-Muting system
External Test used
Optical Synchronization
Timing chart
Beam state: Unblocked
Blocked
Test switch (S1)
Reset switch (S2)
OSSD
Note: 1. When using the Reset Switch Connector (F39-GCNY3), the following functions are not available.
• External Device Monitoring (EDM)
2. For the functional earth connection, refer to page 35.
XS5F-D421 80-F
L1
S2
DIP switch
EDM Disabled (factory default setting)
Manual Reset (Start/
4
Restart Interlock)
5
Long : Open the OPERATING RANGE SELECT INPUT line of the emitter or connect the line to 24 VDC.
Long *6
8
Perform wiring according to the wiring diagram.
N/A
Connect the TEST line of the emitter to 24V/0V of the emitter via a test switch (NO contact). *7
N/A
Open the COM(+) and COM(-) lines of the emitter.
Innteligent Tap
F39-JGR3K-D
F39-GCNY3
F39-JG A-D
IN1 IN2
Safety controller
* 3 * 4
Setting
[Start interlock] : Enable
ON
[Restart interlock] : Enable
ON
[Operating Range Selection] : Long mode *6
ON
[Muting] : Disable *6
[External test signal inversion] : Disable
S1: Test switch
S2: Lockout/interlock reset switch
L1: Lamp
*1. Reverse the polarity of the power supply when using in the NPN
system. Select a PLC and a safety controller of PNP or NPN type
according to the system of your application.
*2. Connect the line to 0 VDC if Operating Range Selection is used in
Short Mode.
*3. Refer to page 75 for more information.
*4. The safety controller and the F3SG-SR must share the power
supply or be connected to the common terminal of the power
supply.
*5. This is the case for a PELV circuit.
*6. Set the function with the DIP Switches on the Intelligent Tap or the
SD Manager 3, restore the settings to the F3SG-SR, and perform
wiring according to the wiring diagram.
*7. This wiring example shows light emission stop when connected to
24 VDC with PNP setting, and light emission stop when
connected to 0 VDC with NPN setting. If TEST switch is not
needed, refer to the User's Manual (Man. No. Z405).
F3SG-SR/PG
Needed
Wiring for NPN * 1
24 VDC
24 VDC
* 5
 : Indicates a switch position.
SD Manager 3
40