Indicator - Omron F3SG-SR/PG Manual

Indicator

LED Indicators on F3SG-SR
Shown below are indication statuses of the LED indicators on the F3SG-SR when you purchased.
Emitter (F3SG-SR)
Location Indicator Name
C
1 Scan code
or
CODE
E
2 Lockout
or
ERR
L
Operating
3
or
range
LONG
T
4 Test
or
TEST
Area Beam
5 --- Indicator (ABI)
(*1)
Top-beam-
6 TOP
state (*1)
Bottom-beam-
7 BTM
state (*1)
*1. The indicator of the emitter is illuminated only in the case the Wired Synchronization is enabled and is off in the case the Optical
Synchronization is enabled.
*2. Configurable by SD Manager 3.
*3. This is the case for the Standard Muting mode. For other muting modes, refer to User's Manual.
*4. The Area Beam Indicator closer to the "TOP" mark on the F3SG-SR blinks.
*5. The Area Beam Indicator closer to the "BTM" mark on the F3SG-SR blinks.
*6. DIP switches is on the Intelligent Tap.
Color Illuminated
Green Code A is selected
Orange Code B is selected
Automatic interference prevention
OFF by wired synchronization being
performed
LOCKOUT state. The indicator is
illuminated in the emitter of another
sensor segment than that having a
Red lockout error (when in cascade
connection or between the emitter
and receiver in the Wired
Synchronization)
Green Long Mode is selected
OFF Short Mode is selected
Yellow ---
The target beams of the ABI are
Green unblocked and the safety outputs
are turned ON
Incident light level of the target
beams of the ABI is 170% (factory
Orange
default setting (*2)) or less of ON-
threshold (for 5 to 10 s)
The target beams of the ABI are
Red
blocked
The target beams of the ABI are
unblocked (The ABI then will be
OFF
illuminated in green when the safety
outputs are turned ON.)
Blue The top beam is unblocked
Blue The bottom beam is unblocked
Blinking
---
LOCKOUT state. The indicator is
illuminated in the emitter of a sensor
segment having a lockout error
LOCKOUT state due to Operating
range selection setting error
External Test is being performed
MUTING or OVERRIDE state. In the
MUTING state, only the ABI
indicators in the muting zone are
blinking. Or the target beams of the
ABI are blocked instantaneously
Incident light level of the target beams
of the ABI is 170% (factory default
setting (*2)) or less of ON threshold
5 to 10 s after illuminated when
incident light level of the target beams
of the ABI is 170% (factory default
setting (*2)) or less of ON threshold.
Or one muting input becomes the ON
state and the MUTING state has not
been started yet, or one muting input
becomes the OFF state and the other
is not in the OFF state yet. (*3)
LOCKOUT state due to Cap error or
Other sensor error (*4), or Lockout
state due to DIP Switch setting error
(*5 *6)
---
MUTING/OVERRIDE state, or
LOCKOUT state due to Cap error or
Other sensor error
MUTING/OVERRIDE, or LOCKOUT
state due to DIP Switch setting error
(*6)
F3SG-SR/PG
F3SG-SRA F3SG-SRB
X X
X X
X X
X X
X ---
--- X
--- X
32