Life Fitness Aspire ASPT-SL Service Manual page 55

4. Rotate incline motor case towards the front of treadmill and under the support tube.
5. Install upper clevis pin through support tube and incline motor.
6. Install cotter pin into upper clevis pin.
7. Connect ferrite to cable and plug into IMDB.
8. Install cable tie securing ferrite to vertical bracket.
9. Remove excess cable tie using side cutters.
Test elevation motor
1. Plug power cord into power outlet.
2. Start treadmill in Manual Mode and raise incline until the 4" (10 cm) blocks can be removed.
3. Remove the 4" (10 cm) blocks.
4. Lower incline to zero percent.
5. Unplug power cord from power outlet.
Install Motor Cover
1. Snap Tinnerman clips on motor cover into place on base frame assembly, motor side shrouds, and front cover.
Item
1
Description
Motor Cover
Item
1
2
3
4
Page 53 of 98
Description
Support tube
Upper clevis pin
Cotter pin
Incline motor
Qty.
1
Qty
1
1
1
1