Table of Contents
Advertisement
TECHNICAL DATASHEET
Force-GT DIN Rail Power Supply
24 V 240 W 3 Phase / DRF-24V240W3GBA
Assembly & Installation
The power supply unit (PSU) can be mounted on 35 mm DIN rails in accordance with EN 60715. The device should be installed with
input terminal block at the bottom.
Each device is delivered ready to install.
1.
Tilt the unit upwards and insert it onto the DIN rail. Snap on the DIN rail as shown in Fig. 3.1.
2.
Push downwards until stopped.
3.
Press against the bottom front side for locking.
4.
Shake the unit slightly to ensure that it is secured.
5.
To uninstall, pull or slide down the latch with screw driver as shown in Fig. 3.2. Then slide the power supply unit (PSU) in the opposite
direction, release the latch and pull out the power supply unit (PSU) from the rail.
Mounting
Fig. 3.1 Mounting
In accordance to IEC/EN/UL/CSA 62368-1 and IEC/EN/UL/CSA 61010-2-201, flexible cables require ferrules.
Use appropriate copper cables designed to sustain operating temperature of:
At least 75°C for ambient < 40°C
•
•
At least 90°C for ambient < 70°C.
9
Dismounting
Fig. 3.2 Dismounting
Advertisement
Table of Contents
