Assembly And Installation; Safety Distance - Delta PMT Series Technical Data Sheet

TECHNICAL DATASHEET
PMT Panel Mount Power Supply
5 V 35 W 1 Phase / PMT-5V35W1A□
Assembly & Installation
Mounting holes for power supply (device). The power supply shall be mounted on minimum 2 mounting holes using M3 screw
Ⓐ
minimum 5 mm length.
This surface belongs to customer's end system or panel where the power supply is mounted.
Ⓑ
Connector
Ⓒ
Side Mounting (Vertical)
PM☐-5V35W1AA / PM☐-5V35W1AG: Use flexible cable (stranded or solid) of AWG No. 18-12. User should calculate and select
•
the suitable wire specification (type/quantity/diameter) according to actual output current. The torque at the Connector shall not
exceed 13Kgf.cm. The insulation stripping length should not exceed 0.275" or 7mm (Refer to Fig. 3).
PM☐-5V35W1AH: Use flexible cable (stranded or solid) of AWG No. 18. Please refer to Table 1 for the recommended Housing and
•
Terminal.
Table 1
Input (JST)
Output (JST)
Fig. 3 Assembly Reference
Ensure the mounted device is kept at ≥ 4 mm safety distance at all sides from other components and equipments. In addition, to ensure
sufficient convection cooling, always maintain a distance of ≥ 20 mm from ventilated surfaces while the device is in operation.
All parameters are specified at 25°C ambient and AC input unless otherwise indicated.
10
www.DeltaPSU.com (February 2022, Rev. 08)
Base Mounting (Vertical)
Fig. 2 Recommended
Connector (Board Mounting)
B3P5-VH(LF)(SN)
B2P3-VH(LF)(SN)
Mounting Orientations
Housing
VHR-5N
VHR-3N

Safety Distance

D1 = 4.0mm Min.
Side Mounting (Horizontal)
Terminal
SVH-21T-P1.1