Dinette/Bed Conversion - Winnebago Vita 2020 Manual

NOTE: Ensure top of ladder is properly engaged
onto retainer brackets and ladder is
resting firmly on floor before using.
Mounting clips are provided by the entrance
door to secure and store the ladder while
traveling or when not in use.

DINETTE/BED CONVERSION

–If Equipped
(Typical View – Your motorhome may
differ in appearance)
Dinette to Bed
1. Remove both dinette back cushions and set
aside.
2. Lift both dinette seat cushions upward.
3. Release the table leg from the floor support
bracket.
Floor
Support
Bracket
FURNITURE AND SOFTGOODS
4. Release the catch on the table leg brace and
fold the leg up against the bottom of the table.
Table Leg
Catch
5. Remove the table from the wall support
bracket by lifting the end of the table.
6. Then lower the table to rest on the cleats
attached to each dinette bench.
7. Arrange one dinette back cushion and two
bolster cushions over table to complete the
bed conversion.
SECTION 9 –
Wall
Support
Table
Bracket
9-3