Table of Contents
Advertisement
NOTICE
Because the slideout roof is drawn into
the interior of the motorhome when
retracted, be sure there is no debris, such
as excessive dirt, tree seeds, twigs,
leaves, etc. on the roof before retracting.
Retract Procedure:
See "Before Retracting!" before proceeding.
•
Engage the parking brake.
•
Start the engine so the alternator can provide
maximum power for proper operation of
slideout mechanisms.
•
Press the Slideout Room "RETRACT/IN"
switch and hold until the room is fully
retracted, then release the switch.
•
To stop retracting the room during operation,
release the button.
•
After the room is retracted, Remove and
Secure the Ignition Key.
SLIDEOUT ROOM – EXTREME
WEATHER PRECAUTION
Certain extreme weather conditions, such as
heavy rains, heavy snow, and high winds, or any
combination of these, could cause damage to the
slideout room cover-awning (if equipped) or
reduce effectiveness of the slideout room weather
seals.
Also, freezing rain and snow can prevent the
slideout cover-awning (if equipped) from closing
and may cause damage to the cover-awning,
slideout room, weather seals, and mechanisms.
To avoid potential damage, we recommend
retracting your slideout room during extreme
weather conditions.
SLIDEOUT ROOMS
SLIDEOUT ROOM
TROUBLESHOOTING (POWER
GEAR
) IN WALL SLIDEOUT
®
–If Equipped
Battery Voltage or Circuit Breaker
Problems
If the slideout room will not work:
•
Turn the Chassis Battery Disconnect switch
OFF (leave off for 20 seconds) and then turn
ON again. This will, in many cases, reset
power to the slideout system.
he chassis battery may be low on charge.
•
Press and Hold the Battery Boost switch
(located on the dash) while pressing the
interior slideout control switch. This
momentarily connects the house batteries to
assist in slideout room operation.
•
The circuit breaker may be tripped. The
circuit breaker, labeled "Slideout" is located
on the outboard side of passenger cab seat.
Problems Retracting or Extending
the Room
• Fault Code
LED
Slideout Control Box
(Located in a driver or passenger side
compartment, depending on model)
-Remove panel to access
If an error is detected on your slide system, the
LED light on the control panel will blink an error
code. If an error code appears, see the In Wall
SECTION 10 –
10-3
Advertisement
Table of Contents
