Winnebago Vita 2020 Manual page 32

SECTION 3 –
DRIVING YOUR MOTORHOME
Inner
rear
dual
4. Using the valve cap tool as a remote handle,
unscrew the valve stem cap (retaining cap in
the end of the valve cap tool).
18-Hole Steel Wheel with Push-On Full
Wheel Trim
NOTE: If the valve stem cap and valve stem
extension unscrew as an assembly, pull
the assembly out of the valve cap tool
end, remove valve stem cap, insert valve
stem extension into valve cap tool, and
reinstall valve stem extension onto valve
stem until snug.
Pull off valve cap tool and re-insert valve
stem cap into end of hose.
5. To check inner dual tire pressure, use the long
handle of the tire gauge to control alignment
and avoid misaligned valve stem deflection.
3-6
Valve
cap tool
6. When tire pressure testing is complete,
reinstall the valve stem cap (with the cap still
retained in the valve cap tool end).
7. Remove valve cap tool from valve stem cap.
Rear Outer Dual Valve Stem
Access
NOTE: Rear Outer Dual is equipped with a fill-
through extension (no valve stem cap).
1. Obtain a double angle push/pull truck tire
gauge.
2. To check rear outer dual tire pressure, use the
long handle of the tire gauge to control
alignment on the fill-through extension.