Table of Contents
Advertisement
Available languages
Available languages
T
roubleshooting
Vacuum cleaner won't turn on
Possible causes
1.
Vacuum cleaner is not plugged in
2.
Power button is not pressed down
3.
Thermal protector activated
Vacuum cleaner won't pick up or low suction
Possible causes
1.
Tools, hose and/or telescoping extension wands are blocked
2.
Filters are dirty
3.
Dirt container is full
4.
Hose not securely attached to suction opening
5.
Crack or hole in flex hose
6.
Air flow regulator or variable suction power control is set
to open or minimum setting
Visible dust escaping from vacuum
Possible causes
1.
Dirt container is full
2.
Filters missing or installed incorrectly
3.
Filters are dirty
4.
Flex hose is blocked
5.
Hose not securely attached to suction opening
6.
Crack or hole in flex hose
Other maintenance or service not included in the manual should be
performed by an authorized service representative.
Please do not return this product to the store.
14
w w w . b i s s e l l . c a
w w w . b i s s e l l . c a
Thank you for selecting a BISSELL product.
WARNING:
To reduce the risk of electric shock,
turn power OFF and disconnect plug
from electrical outlet before performing
maintenance or troubleshooting.
Remedies
1.
Check electrical plug
2.
Press power button down
3.
Allow cleaner to cool for 2 hours. See page 13.
Remedies
1.
Remove each part and check for blockages
2.
Check and clean or replace pre-motor and post-motor filters
3.
Empty dirt container
4.
Make sure hose connector is locked into suction opening
5.
Check hose and replace if needed
6.
Change to closed or maximum setting
Remedies
1.
Empty dirt container
2.
Check pre-motor and post-motor filter for correct installation
3.
Check and clean or replace pre-motor and post-motor filters
4.
Remove hose and check for blockages
5.
Make sure hose connector is locked into suction opening
6.
Check hose and replace if needed
1 - 8 0 0 . 2 6 3 . 2 5 3 5
15
8 0 0 . 2 6 3 . 2 5 3 5
Advertisement
Table of Contents
