Bissell POWERFORCE POWERTRAK 31L9 Series User Manual page 10

O
perations
Air flow Regulator
The variable suction power control is located behind
the handle. Slide the control down for maximum
suction. Slide the control up to minimize suction for
lightly soiled areas or delicate fabrics.
Variable suction power control
The variable suction power control is located on the
back of the vacuum.
Turn the control toward the larger dots for maximum
suction. Turn the control toward the smaller dots to
minimize suction for lightly soiled areas or delicate
fabrics.
Variable height adjustments
Step on the brush height adjuster located on the right
side of the motorized powerhead to adjust for flooring
type (lowest setting (1) for low pile carpet, highest
setting (6) for high pile carpet).
Turn power brush OFF for hard floor surfaces.
CAUTION:
Before using your vacuum, make
sure that the dirt container and all
filters (pre-motor and post-motor)
are in place. Do not operate your
vacuum without the dirt container
and filters.
8
w w w . b i s s e l l . c a
w w w . b i s s e l l . c a
Air flow Regulator
PowerBrush On/Off
Tip:
Use the variable suction
power control and the air flow
regulator to reduce air flow as
needed when using the tools.
Variable
Suction
Control
Variable Height Adjustments
8 0 0 . 2 6 3 . 2 5 3 5
1 - 8 0 0 . 2 6 3 . 2 5 3 5
7