Introduction - RTS EKP96 Operating Instructions Manual

1

INTRODUCTION

This manual describes the operating procedures for the KP96/KP97 keypanels when used in an ADAM, ADAM CS,
or Zeus Intercom System. The operating procedures are divided into two parts: "Basic Keypanel Operation"
(page 7) which describes how to talk and listen over the intercom system, and "Advanced Operations" (page 9)
which describes how to program key assignments, change setup pages, and display information about the key-
panel setup. If you are using a keypanel that has already been setup by a system administrator, you may only need
to refer to the basic operating information. If you need to change the keypanel setup or access other information
about the keypanel setup, you will need to refer to the advanced operation information.
This manual was revised to describe the operation of keypanel firmware version 8.3G. (To find out what version
of firmware is currently installed in your KP96 or KP97 keypanel, see "Display Requests using Scrolling", page
11). Version 8.3G adds support for the LCP-100A Level Control Panel, and removes the MVOL (master volume)
adjustment. (MVOL let the user adjust the overall gain for an intercom port. It was intended as an adjustment
when a port was being overloaded by too many inputs, but practical experience has revealed that this adjustment
is virtually never required, and that misuse of the adjustment leads to other level and noise problems.) If you need
to make volume adjustments to the listens for individual intercom port or party line assignments, either use the
gain adjust feature (page 12) or consider using LCP-100A Level Control Panels. In some cases, unacceptably high
or low volume levels for particular intercom port assignments may be due to an audio source connected to that
port which is operating at a non-standard level for the intercom system. In such cases, all users at all ports will
hear the audio source at the wrong level. To correct this, it is better to use the Analog Input/Ouput Gain feature,
which is available in the intercom system configuration software.
1 2 3
DIR PROD RACK PL01
Talk
Off
(Talk)
BY
Matrix Intercom System
1. Designation Strip Holder
2. Display Window
3. Listen Keys
4. Gooseneck Microphone
Figure 1: Keypanel Reference View. (Features may vary, depending on model.)
4
Listen
IFB4 TD AD NEWS SAT1 TEL1
Talk
9
5. Headset On/Off Key
6. Programming Keypad and Loudspeaker
7. External Line Input Volume
8. Intercom Volume
TEL2 FLOR CHYR IS01 IS02 AUD1
Incoming Messages
Programing
10. Incoming Messages Window
11. Headset Connector
KP96/KP97 Keypanel Operation Manual, Ver. 8.3G 5
5 6
NUM PL AUTO
1 2 3
HDST
SLIST IFB ISO
PREFIX
PHONE
5
4 6
RELAY TYPE
COPY CW E-PNL
7 8 9
Clear
EX COPY DISP
Off
Call
Answer
MULT
CLR 0 PGM
FUNC
10
9. Talk Keys
and Key
7 8
Volume
Dyn Mic
Headset
11