Honeywell MetroSelect Eclipse MS 5145 Configuration Manual page 105

Activation Mode Features
³ 9 1 9 6
³ 1 2 0 3
³ 4 1 8 3
³ 1 1 8 1
³ 1 1 8 1
³ 1 1 8 3
³ 1 1 8 3
³ 1 1 9 9
³ 1 2 0 3
22–2
~ Variable Laser-On Time Out – Scan this bar
code with a code byte sequence (on page 16–1)
0 0
that represents the desired time out increment.
The configurable time increment (1-second
increments) selected is the scanning laser-on
time.
Allow Full Laser-On Cycle – The laser stays on
for a full cycle even when a bar code is scanned
1 4
and transmitted.
Blinky Mode – The laser turns on after the
selected activation trigger is detected. The laser
2 4
will blink on/off for approximately 30 seconds.
Transmit a NO READ Message on Laser Time
Out – If the scanning cycle terminates without
1 1
scanning a bar code during the cycle, a NO READ
message is transmitted with the termination of the
scanning cycle.
Do Not Transmit a NO READ Message on Laser
Time Out
0 1
Activate the LED during the NO READ
Transmission – The LED is output with the NO
1 1
READ message.
Deactivate LED during the NO READ
Transmission
0 1
Enable RTS No Read Pulse – A configurable
RTS pulse width transmitted after the NO READ
1 7
message has been transmitted.
Disable RTS No Read Pulse
0 3