MS9520-00 and MS9540-00 Laser Emulation Mode
The MS9520-00 and MS9540-00 leave the factory with Laser Emulation
interface enabled.
If you recall defaults while re-configuring your scanner, scan the following bar
code to re-enable the Laser Emulation interface. The scanner you are using
must be labeled as an MS9520-00 or MS9540-00 to support this feature.
If host controlled laser emulation is required scan the following bar code after
scanning the Enable HH Laser Emulation bar code.
³
1
1
7
0
³
1
1
7
0
17–4
Enable HH Laser Emulation
³
9
Enable Host Controlled Laser Emulation
³
1
Normal Laser Emulation Motor Idle State
0
1
Reverse Laser Emulation Motor Idle State
1
1
9
9
9
7
9
1
7
0
1
0