Monitoring Functions - Triaxhd Adapter - THOMSON grass valley LDK 6000 MKII Series User Manual

Monitoring Functions - TriaxHD adapter

CVBS (option)
1
2
3
VF
Front Rear 48V
Scrip
Light
Breaker
Power on
TP
4 Ext 1
Ext 2
12V 1,5A DC Out
CVBS output connector
1
This BNC connector provides a 1Vpp CVBS viewing output
signal with the same frame frequency.
Viewfinder / External video output connector
2
This BNC connector carries the viewfinder signal or the
external video signal from the Base Station depending on the
positon of switch (3).
Video output selection switch
3
This switch determines whether the viewfinder signal from
the camera or the external video signal from the Base Station
is available at connector (2).
External signal selection switch
4
This switch selects either the EXT1 or EXT 2 signal for display
in the viewfinder when the viewfinder signal selection switch
(6) is in the EXT position.
Viewfinder selection switch
5
This switch is used to select the camera Y signal or an
external signal - set with (6) - for display in the viewfinder. The
Ret. button on the lens also selects this signal in parallel with
this switch.
Note: This switch is disabled when the SuperXPander is
used.
External signal selection switch
6
This switch is not used in the LDK6000
Location of Controls
6
Eng Front
Off
Prod Rear
Ext Loc
5
Mix
Call
Mic
Ext
DC in
48V On
Mic 2
Operator's Manual - LDK 6000 mkII
8
7
VTR button (camera)
7
The function of this button is set in the Install menu. It can be
used to:
• switch the intercom microphone of the headset to the
production intercom channel.
• control the viewfinder zoom function.
• select the EXT 1 signal to display in the viewfinder.
• select the EXT 2 signal to display in the viewfinder.
The method of controlling the viewfinder zoom function is also
selected in theInstall menu. If set to MOM, zoom is only active
while the button is pressed. If set to ALT, the button acts as
a switch.
VTR button (lens)
8
The function of this button is also set in the Install menu. This
button can operate independently of the VTR button on the
camera. It can be used to:
• switch the intercom microphone of the headset to the
production intercom channel.
• control the viewfinder zoom function.
• select the EXT 1 signal to display in the viewfinder.
• select the EXT 2 signal to display in the viewfinder.
The method of controlling the viewfinder zoom function is also
selected in theInstall menu. If set to MOM, zoom is only active
while the button is pressed. If set to ALT, the button acts as
a switch.
Note: When the camera is used with a large lens adapter,
the function of the RET 2 switch on a zoom control can
be set in the Install menu. The RET2 switch can then
be used either to select EXT 2 for display in the
viewfinder or to switch the viewfinder zoom function.
(RET1 is selectable at the rear of the Triax adapter.)
4-7