Table of Contents
Advertisement
Microphone
3
To attach the optional microphone (AJ MC700) to the camera
proceed as follows:
a. Open the microphone holder by unscrewing the knurled
screw (1) of the microphone support bracket (2) on the
viewfinder and open.
b. Slide the microphone into the split tube until the microphone
shoulder reaches the mark (5) in the tube.
c. Place the tube with the microphone into the holder with
the split facing upwards.
d. Ensure that the rubber supports at the back and front of
the holder fit into the rims (6)around the tube.
e. Close the holder and tighten the knurled screw at the top.
f.
Connect the microphone cable to audio connector (3)
(mic) on the right side of the camera.
g. Place the microphone cable into the top clip at the front of
the camera and into clip (4) at the side of the camera.(Pull
and twist clip (4) to open it.)
Other microphones with a diameter of 21mm can also be
used, however, ensure that the phantom power and the
sensitivity of the input that match that type of microphone are
correctly selected in the camera systems menu. Refer to
Section 6 for more information on selecting the audio inputs
and controlling the audio level.
Assembling the Units
5
2
1
4
Operator's Manual - LDK 6000 mkII
6
Note:
•
When longer microphones are used, it is not necessary to
place them in the split tube.
•
For optimum operation, the microphone should be mounted
as straight as possible.
•
Don't allow the wind hood to touch the holder (7) as this
reduces the damping effect.
•
By placing the split facing upwards, the microphone cable
does not touch the holder thus avoiding mechanical pick-
up.
•
The microphone can also be connected to the rear of the
Triax adapter where a switch selects the input. Refer to
Section 4 for more information on connecting the
microphone to the rear connector.
6
7
2-7
Advertisement
Table of Contents
