Table of Contents
Advertisement
Replacing the Fuel Filter
Service Interval: Every 800 hours/Yearly (whichever
comes first)
Do not install a dirty filter if it is removed from the fuel
line.
Note:
Wipe up any spilled fuel.
1.
Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Close the fuel-shutoff valve; refer to
Fuel-Shutoff Valve (page
4.
Replace the fuel filter as shown in
Figure 60
Using the
21).
Figure
60.
g027518
Electrical System
Maintenance
Electrical System Safety
•
Disconnect the battery or remove the spark-plug
wire before making any repairs. Disconnect the
negative terminal first and the positive terminal
last. Connect the positive terminal first and
negative last.
•
Charge the battery in an open, well-ventilated
area, away from sparks and flames. Unplug the
charger before connecting or disconnecting the
battery. Wear protective clothing and use insulated
tools.
Servicing the Battery
Service Interval: Every 100 hours
Always keep the battery clean and fully charged. Use
a paper towel to clean the battery case. If the battery
terminals are corroded, clean them with a solution of
four parts water and 1 part baking soda. Apply a light
coating of grease to the battery terminals to prevent
corrosion.
Voltage: 12 V
Removing the Battery
1.
Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Remove the battery as shown in
40
Figure
61.
Advertisement
Table of Contents
