Replacing The Transmission Belt - Toro 72542TE Operator's Manual

Replacing the Transmission
Belt
Service Interval: Every 1,000 hours—Replace the
transmission belt.
1. Remove the fuel tank; refer to
Fuel Tank (page
2. Remove the hydraulic-reservoir cap.
3. Locate the drain plugs in the bottom of the
transmission and place a drain pan under the
plug (Figure 80).
Figure 80
1. Drain plug
4. Allow the hydraulic fluid to drain from the
machine.
5. Remove the lower hydraulic hose
Figure 81
1. Lower hydraulic hose
2. Transmission belt
6. Remove the tension spring
Removing the
39).
(Figure
3. Tension spring
(Figure 81).
CAUTION
The spring is under tension when
installed and can cause personal injury.
Wear safety glasses and be careful when
removing the spring.
7. Remove the transmission belt from the clutch
and clutch stop
8. Install the new belt.
9. Install the tension spring and lower hydraulic
hose.
10. Install the drain plugs and torque to 22 to 27
N∙m (16 to 20 ft-lb).
11. Add hydraulic fluid to the fill level.
12. Install the hydraulic-reservoir cap.
13. Run the machine for 10 minutes and verify that
the hydraulic fluid is at the correct level.
g267274
81).
g031345
49
(Figure 81).