Table of Contents
Advertisement
Greasing the Motion
Controls
Service Interval: Yearly
Grease the operator-presence-control balljoint and
the motion-control bushing for both levers.
Note:
Use an oil drip between the lever brackets to
grease the bushing, located in the pivot tube.
Figure 48
1. Operator-presence control
balljoint
g228034
2. Pivot tube
Engine Maintenance
Engine Safety
•
Shut off the engine before checking the oil or
adding oil to the crankcase.
•
Keep your hands, feet, face, clothing, and other
body parts away from the muffler and other hot
surfaces.
Servicing the Air Cleaner
Every 250 hours—Replace the primary air filter
(more often in dirty or dusty conditions).
Every 250 hours—Check the inner air filter
(more often in dirty or dusty conditions).
Every 500 hours—Replace the inner air filter
(more often in dirty or dusty conditions).
Removing the Filters
1.
Disengage the PTO, move the motion-control
levers to the N
engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Open the engine guard; refer to
Engine Guard and Guard Extension (page
4.
Release the retaining clamps on the air cleaner
and pull the air-cleaner cover off the air-cleaner
body
(Figure
49).
1. Air-cleaner clamps
2. Air-cleaner cover
5.
Clean the inside of the air-cleaner cover with
compressed air.
6.
Gently slide the primary filter out of the
air-cleaner body
34
-
position, and
EUTRAL
LOCK
Opening the
Figure 49
3. Primary filter
4. Inner filter
(Figure
49).
26).
g026970
Advertisement
Table of Contents
