Brother MFC-J5335DW Service Manual page 240

9.52 Paper Feed Motor
(1) Remove the two screws (SCREW BIND M3x6) from the CR guide rail.
(2) Remove the two screws (TAPTITE CUP B M3x10) from the CR guide rail.
Assembling Note: When tightening the two screws (TAPTITE CUP B M3x10), tighten
(3) Remove the two CR guide rail springs.
(4) Remove the CR guide rail from the Main body.
CR guide rail spring
SCREW BIND M3x6
CR guide rail
SCREW BIND M3x6
Main body
Note: Do not place the removed CR guide rail with the Recording paper holder down.
Recording paper holder
them in the order shown in the figure.
TAPTITE CUP B M3x10
Fig. 3-142
Wrong
CR guide rail
Correct
Fig. 3-143
3-116
CR guide rail
spring
1
Recording paper holder
CR guide rail
2
Maintenance
unit
Confidential