Brother MFC-J5335DW Service Manual page 227

(6) Remove the three screws (TAPTITE CUP B M3x10) from the CR frame ASSY.
Assembling Note: When tightening the three screws (TAPTITE CUP B M3x10),
tighten them in the order shown in the figure.
(7) Remove the two CR frame springs from the CR frame ASSY.
(8) Remove the CR frame ASSY from the Main body.
TAPTITE CUP B
M3X10
(9) Remove the Guard film from the Guard film spring.
(10)Remove the Guard film from the CR frame ASSY.
Note: When performing this procedure, place the unit in a way that the section "A" of
the Carriage motor harness will not be damaged.
Guard film
CR frame ASSY
CR frame spring
CR frame spring
7
CR frame ASSY
3
Fig. 3-121
10
Guard film
Fig. 3-122
3-103
TAPTITE CUP B M3x10
2
1
8
9b
9a
Guard film spring
Carriage motor
harness
Main body
"A"
Carriage motor harness
Confidential