Evaporator Reassembly - Follett Horizon Elite HC-1810R/N Operation And Service Manual

Evaporator reassembly

14. Install ceramic mating ring and shaft seal.
Caution: Do not touch the sealed surface of either
part. Oil from bare skin will cause premature seal
failure.
15. Use liquid hand soap on the rubber part of the
ceramic seal when installing in main housing. Use
supplied cardboard disc to press into recess.
16. Apply liquid hand soap to raised area of auger shaft
and interior rubber portion of shaft seal before
installing seal.
17. Clean O ring groove. Lubricate O ring with petrol-
gel and reinstall.
18. Carefully install auger.
19. Rotate auger to position shown to clear main
housing stream divider.
20. Install rear shuttle insulation (Fig. 22.1) and slide
main housing (Fig. 22.2) onto auger.
21. When installing new water seal, use screwdriver to
compress the spring (Fig. 22.3), which allows for
easier installation of the three screws.
24
Fig. 20
Do NOT
touch!
Fig. 21
Fig. 22
HC_1810R/N, HC_2110R/N, HM_1810R/N, HM_2110R/N
Cardboard
disc
1
2
3