How To Change The Ip Address - Emerson Copeland Site Supervisor Controller Quick Setup Manual

How to Change the IP Address

Method 1: Direct Connect
1. Select the Main Menu icon
Settings:
On the INTERNET (TCP/IP) section on the screen, enter the IP Address in the ETH 0 IP Address field.
2.
Note that you can set up the Peer Group, Unit Number, Network Mask, and Default Gateway on
Method 2: USB Port
1. Create a "network.txt" with your desired settings (Enter IP Address in the ETH 0 IP Address Field):
2. Save to the root folder of a thumb drive. Insert the thumb drive into the USB port of E3.
3. Power cycle the E3. The new IP Address will be saved.
9
> Configure System > General System Properties > Network
Enter IP Address in the ETH 0 IP Address Field
this screen.
Network.txt Notepad