How To Locate The Ip Address Of Site Supervisor - Emerson Site Supervisor User Manual
Hide thumbs
Also See for Site Supervisor:
- Quick setup manual (10 pages) ,
- Quick setup manual (9 pages)
Table of Contents
Advertisement
8.2
How to Locate the IP Address of Site Supervisor
1.
On a blank USB drive, create a new Text Document.
Figure 8-4
- Creating a Blank Text Document
2.
Name the text document ipme.txt.
Figure 8-5
- Saving the Document as ipme.txt
3.
Remove the USB drive from the PC, power down
the Site Supervisor, then insert the USB drive.
4.
Power up the Site Supervisor; its green status will
flash during the power-on cycle. Once the light
stops blinking and turns solid, remove the USB
Drive.
5.
Insert the USB drive into the PC, then open the
USB drive.
•
8-2
Site Supervisor Controller User Guide 2.0
026-1800 Rev 3 02-AUG-2016
Advertisement
Table of Contents
