Blade Installation - Honeywell TOUCHDOWN Manual

19. Remove motor screws from underside of motor
and save for blade arm attachment. Discard the
plastic motor blocks but keep the screws (Fig. 19).
Motor Screw
20. Partially insert the three blade screws along
with the washers through the blade and into the
blade arm. Starting with the center blade screw,
tighten the blade screws. Repeat this step for the
remaining blades and blade arms (Fig. 20).
Blade Screw Washer
21. Insert two previously removed motor screws through
one blade arm and blade isolator and into the
motor. Tighten motor screws securely. Repeat with
remaining blade arms, making sure to completely
secure each blade arm before proceeding with to the
next (Fig. 21).
Note: A cutout in the upper switch housing allows easy
access to the motor screw holes.
Motor Screw

BLADE INSTALLATION

Motor Block
Fig. 19
Motor Screw
Fig. 20
Blade Arm
Fig. 21
Motor Screw
13
Motor Block
Blade Screw
Washer
Blade
Cutout
Blade Isolator
Blade Arm