Light Kit Installation; Light Kit; Optional Cap - Honeywell TOUCHDOWN Manual

22. (Optional) To install the fan without a light kit:
Remove the three screws and washers from the
upper switch housing. Align holes in optional cap
with holes in upper switch housing. Re-insert
screws and washers that were previously removed.
Use a Phillips screwdriver (not included) to secure
all screws (Fig. 22).
Proceed to step 28.
Screw Washer
23. To install the fan with a light kit: Remove the
three screws and washers from upper switch
housing. Connect the single pin connectors from
the light kit to the single pin connectors from the
upper switch housing -- black to blue and white to
white. Make sure plugs connect tightly (Fig. 23).
Screw Washer
24. Align holes in the light kit with holes in upper switch
housing. Re-insert screws and washers that were
previously removed. Use a Phillips screwdriver (not
included) to secure all screws (Fig. 24).
Screw Washer

LIGHT KIT INSTALLATION

14
Fig. 22
Optional
Cap
Fig. 23
Upper
Switch
Housing
Light
Kit
Fig. 24
Screw and
Washer
Screw
and
Washer
Screw
and
Washer