Blade Installation - Honeywell 50198 Manual

18. Remove the ten motor screws from underside of
motor and save for blade arm attachment. Discard the
plastic motor blocks but keep the screws (Fig. 18).
Motor Screw
19. Partially insert three blade screws along with
spring washers and flat washers to attach the blade
arm to the blade. Then, tighten each blade screw
starting with the one in the middle. Repeat with
remaining blades (Fig. 19).
Blade Screw Spring Washer
20. Insert two previously removed motor screws through
one blade arm and blade isolator and then into the
motor. Tighten motor screws securely. Repeat with
remaining blade arms, making sure to completely
secure each blade arm before proceeding with to the
next (Fig. 20).
Motor Screw

BLADE INSTALLATION

Motor Block
Flat Washer
Fig. 18
Fig. 19
Blade Screw
Spring
Washer
Flat Washer
Fig. 20
13
Motor Block
Motor Screw
Blade Arm
Blade Arm
Blade Isolator
Motor Screw
Blade