Table of Contents
Advertisement
19. Remove the ten motor screws from underside of
motor and save for blade arm attachment. Discard
the five plastic motor blocks but keep the screws
(Fig. 19).
Motor Screw
20. The blades attach to blade arms using the Fast
TM
Attach
system. Align each twist lock connector in
the direction of its corresponding hole in the blade.
Place the blade over the twist lock connectors.
Rotate each twist lock connector so that it is
perpendicular to the hole in the blade. Repeat for
the remaining blades (Fig. 20).
Note: A cutout in the upper switch housing allows
easy access to the motor screw holes.
21. Insert two of the previously removed motor screws
through the blade arm and blade isolator and into
the motor. Tighten the motor screws securely.
Repeat this step for the remaining blade arms.
(Fig. 21).
Motor Screw
BLADE INSTALLATION
Motor Block
Fig. 19
Fig. 20
Fig. 21
Blade Isolator
13
Motor Block
Motor Screw
Blade
Blade Arm
Twist Lock
Connector
Cutout
Blade Arm
Motor Screw
Advertisement
Table of Contents
